Original Instructions
13
ASSEMBLY and
OPERATION
WARNING! Do not connect the chain saw to mains before it is completely assembled. Always
use gloves when handling the chain.
Assembly / Replacement of the Guide Bar and Chain
The chain must be so fitted over the guide bar that the cutting edges of the cutters (a) face in the direction that the
chain runs.
Hold the guide bar with the nose upwards and place the saw chain so on sprocket of the guide bar engage into
the chain links and the bottom sections of the drive links are situated in the groove of the bar. The chain is
correctly tensioned when it is still possible to raise it by 2-4 mm. The direction of rotation of the saw chain is
indicated by two arrows on the drive-sprocket cover.
Chain and chain bar assembly:
- Unpack all parts carefully.
- Place the chain saw on any suitable flat surface with the motor facing downwards.
- Fit the chain onto the drive sprocket and guide the chain bar. So that the fastening bolt lit into the keyway of the
chain bar. Check if all parts are seated properly and hold chain and chain bar in a level position.
- Fit cover. Check that arrows are still aligned
- Use the chain tension knob to get the correct tension in the chain. Finally tighten the sprocket cover knob.
Battery pack assembly
Put the battery pack(15) as shown above, taking care to press any button to prevent accidental Starting.
LUBRICATION
Important: the chain saw is not supplied filled with oil. It is essential to fill with oil before use.
Never operate the chain saw without chain oil or at an empty oil tank level, as this will result in
extensive damage to the product.