Note: When the battery power/voltage is getting low you
will typically find that significant rudder trim and/or
rudder stick adjustments are needed
to prevent the
helicopter from spinning. This usually occurs before soft
LVC, and indicates a good time to stop flying.
If you have any fur ther questions or concer ns regarding the
handling, charging and/or use of the included Li-Po batter y
pack,please contact TEL:0086-21-52919366, EMAIL:
Also, it is not recommended that you fly to the soft LVC every
time you fly. Instead, you should be aware of the power level of
the battery/helicopter throughout the flight, and if at any time
the helicopter begins to require more throttle than typical to
maintain hover or flight, you should land the helicopter
immediately. Routinely discharging the battery to the soft LVC
can still cause permanent damage to the battery.
11
www
.
NineEagle
.
com
Batter y Charging
A
.
Ensure the transmitter contain batteries with enough power
B
.
Take off the battery cover
of the transmitter.
C
.
Slide the li-po battery into the
slot on the transmitter until you
make the connection successfully
.the indicative led light on the
charger will solid red
.
Installing the Transmitter Batter y
1
.
Take off the transmitter cover
2.Install four(4) AA batteries in the transmitter
3.
Turn on the power , check if there is any content on LCD
Installing Li-Po Batter y
to the Helicopter
Slide the li-po battery into the battery slot on frame of helicopter
(usually with the label on the battery facing outward) .however, be
sure to check for proper alignment and polarity before proceeding to
the next step.
D
.
when the battery is fully charged the Led light will go out entirely
E.You must take out the li-po when it finishes the charge process.
12
www
.
NineEagle
.
com