15
Service manual
8
Setting of drying programme
There are options for optimizing the drying cabinet’s two automatic programmes for best results.
This is done by adjusting parameter values for the automatic programme concerned on the
control panel.
Values are displayed as follows:
The current parameter is shown on the top line of the display, e.g.
“P 2071”,
the set value of the
parameter is shown on the bottom line.
Changes should only be made if you find that:
p
the washing is not dried sufficiently
p
the washing is over-dried – long drying time.
8.1 Introduction
The drying cabinet is equipped with two drying programmes, Normal dry and Extra dry.
Normal dry programme
is controlled through moisture sensor.
Extra dry programme
is controlled through moisture sensor and a time factor.
The automatic programmes end automatically when the washing is dry.
To decide when the washing is dry, a measured value is compared with a factory-set parameter,
parameter
P 2072 for Normal dry automatic programme and
parameter
P 2071 for Extra dry automatic programme.
It is primarily these two parameters that are adjusted to optimise the drying process.
p
If you find that washing is not dried sufficiently in:
Normal dry automatic programme
reduce
the parameter value for P 2072.
Extra dry automatic programme
increase
the parameter value for P 2071.
p
If you find that washing is over-dried, long drying time in:
Normal dry automatic programme
increase
the parameter value for P 2072.
Extra dry automatic programme
reduce
the parameter value for P 2071.
Optimisation of the drying process must always take place in small steps, start by adjusting the
parameter concerned by 1-2 units up or down, then check the result after the next drying process
and if appropriate make a further adjustment.
Содержание ECO Dryer 2.0 HP
Страница 21: ...21 Service manual Door switch Front panel with door switch Lock washer ...
Страница 23: ......
Страница 24: ...Gematech Innovation ...