EN
ENGLISH
-4-
Nilfisk ALTO
Operator's Manual (EN) - SCRUBTEC 866, 871, 866, Boost 8 and 871C
WARNING:
Electrical components of this machine can "short-out" if exposed to water or moisture. Keep the
electrical components of the machine dry. Wipe the machine down after each use. For storage,
keep the machine in a dry building.
WARNING:
To reduce the risk of fire, when replacing fuse, replace only with same type and rating of fuse
that comes with machine.
WARNING:
Operating a machine without observing all labels and instructional information could result in
injury or damage. Read all machine labels before attempting to operate. Make sure all of the
labels and instructional information are attached or fastened to the machine. Get replacement
labels and plates from your Nilfisk ALTO distributor.
WARNING:
Wet floor surfaces can be slippery. Water solutions or cleaning materials used with this type of
machine can leave wet areas on the floor surface. These areas can cause a dangerous
condition for the operator or other persons. Always put "Caution" signs around/near the area
you are cleaning.
WARNING:
Improper discharge of waste water may damage the environment and be illegal. The United
States Environmental Protection Agency has established certain regulations regarding dis-
charge of waste water. Also, city and state regulations regarding this discharge may be in your
area. Understand and follow the regulations in your area. Be aware of the environmental
hazards of chemicals that you dispose.
CAUTION:
Use of this machine to move other objects or to climb on could result in injury or damage. Do
not use this machine as a step or furniture. Do not ride on this machine.
CAUTION
:
Your machine warranty will be voided if anything other than genuine Nilfisk ALTO parts are used
on your machine. Always use Nilfisk ALTO parts for replacement.
Introduction
:
Scrubtec 866, 871, 886, BOOST 8 and 871C automatic scrubbers are efficient and superior floor cleaning
machines. The Scrubtec 886 uses two brushes or pads to scrub a path 86 cm wide. The Scrubtec 871 uses
two brushes or pads to scrub a path 71 cm wide. The Scrubtec 866 uses two brushes or pads to scrub a
path 66 cm wide. The Scrubtec BOOST 8 uses one pad or brush to scrub a path 71 cm wide. The Scrubtec
871C uses two brushes to scrub a path 71 cm wide. A squeegee wipes the floor while the vacuum motor
removes the dirty solution from the floor in one pass.
Scrubtec 866, 871, 886, BOOST 8 and 871C automatic scrubbers come complete with three battery connec-
tor cables, one battery cable, one battery charger and one operator’s manual.
