41
EN
8 Further information
8.1
Recycling the washer
If the washer is discarded,
make it unusable immediately
1. Unplug the washer and cut
the power cord.
The washer contains valuable
materials that should be recy-
cled. Therefore, make use of
your local waste disposal site.
Contact your local authorities or
your nearest dealer for further
information.
7 Troubleshooting
Fault
Cause
Remedy
Pressure drop
>
Air in the system
•
Vent the system by operating
the spray handle several times
at short intervals. If necessary,
operate the washer for a short
time without the high-pressure
hose connected.
> High pressure nozzle blocked
worn
•
Clean/replace the high pressu-
re nozzle
Pressure fl uctuations
>
Pump draws in air (only possible
in suction mode)
•
Check that the suction set is
air-tight
>
Lack of water
•
Open water tap
>
Water inlet hose is too long or its
cross-section too small
•
Use specifi ed water inlet hose
>
Lack of water caused by blocked
water fi lter
•
Clean the water fi lter in the
water connection (never work
without water fi lter)
>
Lack of water because max.
permissible suction height has
not been heeded
•
See instructions
The motor does not start when the
washer is switched on
>
The plug is not inserted properly,
i.e. there is no current
•
Check the plug, lead and
switch and if necessary have
them replaced by a trained
electrician
>
The mains fuse is switched off
•
Switch on the mains fuse
When the washer is switched on
the motor buzzes without starting
>
The mains voltage is too low
•
Have the electrical connection
checked
>
The pump is blocked or frozen
•
Contact the customer service
>
Incorrect cross-section or length
of the extension lead
•
Use lead with correct cross
section or length
The motor switches off
>
The overload protection has
been activated due to overheat-
ing or overloading of the motor
•
Check that the mains vol tage
and the washer voltage are
the same. Switch off the was-
her and allow it to cool for at
least 3 minutes
>
High-pressure nozzle is dirty
•
Change the high-pressure
nozzle
Water outfl ow under the machine
>
Machine runs longer than 3 mi-
nutes with spray handle closed
•
Switch off the machine