Nilfisk-Advance SR 2000, Инструкция по эксплуатации

Страница: 14 / 44

A-14 / ENGLISH
A-14 - FORM NO. 56041749 - SR 2000
OPERATING INSTRUCTIONS
NOTE
After stopping the engine, perform these post operation checks.
POST-OPERATION CHECK LIST
1. Clean debris hopper.
2. Check brooms for wear or damage.
3. Check
all fl aps for wear, damage and adjustment.
4. Fill the fuel tank.
WARNING!
The gasoline tank access is located behind the driver’s seat.
DO NOT mistake the hydraulic reservoir for the fuel tank.
5. Check all systems for leaks.
FIGURE 11a
TO EMPTY DEBRIS HOPPER
1. Set engine throttle to full throttle position.
2. Push the hopper rotate and dump lever
(S) to the “DUMP” position. The hopper will begin to rotate.
3. Once the hopper rotation speed doubles, the hopper lift lever (R) will work. Raise the hopper to the desired level (MINIMUM OF 8” or 20 cm OF LIFT
REQUIRED) by pulling back the hopper lift lever (R) to the “RAISE” position.
4. Drive forward 12 to 18 inches slowly with the hopper up before completing the dump cycle.
5. Push the hopper rotation and dump lever
(S) to the “DUMP” position to complete dump cycle.
6. Drive in reverse 12 to 18 inches or 30 to 46 cm. slowly with the hopper up to clear the dumpster before lowering the hopper.
7. Pull the hopper rotation and dump lever
(S) to the “RETURN” position and the hopper will automatically rotate and lower to its proper position.
WARNING!
Never turn off the engine with the hopper in the lifted position.