10
Original Instructions
EN
SC DELTA
in water tank, Slave #1 or #2 communication failure. These
warnings won´t stop the machine.
The actual warning will be shown on the Display, to reset
press the aff ected MPU or the water tank where the warning
Symbol
Ref # Function
Signal
Action
1
- Actual water temp.
- Reset water temp. error
Red - water temperature error - Check inlet water tempera-
ture - if OK, contact Service
2
- Actual line pressure
- Reset output pressure low
limit (option)
Red - output pressure low limit
error (option)
- Check water fl ow
- Check available pumps
3
- Start machine
Flash green - control system in
self-validation mode.
Green - machine active
4
- Stop machine
- Reset warning / error
Flash red - system warning
Red - system error
Check below points:
- MPU oil level
- MPU internal heat sensor
- MPU overload protection
- WBT below normal level
- Inverter failure
- Water level error
MPU
5
Red - actual MPU# temperature
warning
- Check air intake MPU
MPU
6
Red - oil level low actual MPU# - Check oil level
B.2.7 Display
FIG. 1
is active and the system will validate that the warnings is
gone and set the system to normal status again.
The reset is done without stopping the machine totally.
Содержание SC DELTA
