Nilfisk-Advance RS 1300, Руководство пользователя

Страница: 146 / 224

ENGLISH
USER MANUAL
24 33014091(3)2008-02 A RS 1300
HOPPER DUMPING
The maximum hopper dumping height is 63.0 in (1,600 mm).
Dump the hopper according to the following procedure.
Turn off the dust control system water pump with the switch (27, Fig. D).
If open, close the dust control system taps (10, 11, 12, Fig. E).
Lift the 3rd broom by pushing the joystick (46, Fig. D) rearward.
Lift the suction inlet and side brooms by pressing the push-button (37, Fig. D).
Stop the 3rd broom and side broom rotation with the switch (29, Fig. D).
When the brooms turn off, the suction fan turns off automatically.
Drive the machine to the appointed dumping area.
WARNING!
Perform the hopper dumping on a solid and level ground, to avoid machine unbalance.
Keep people away from the machine and especially from the hopper (6, Fig. G).
If the hopper may contain a lot of water, it is possible to drain it before lifting and dumping the hopper according to the following
procedure:
Engage the parking brake with the lever (13, Fig. E) and get out of the machine.
Open the left upper lid (9, Fig. G) by disengaging the relevant fasteners (10).
Disengage the hose (26, Fig. F) and drain the water from the hopper.
Install the hose (26, Fig. F).
Open the left upper lid (9, Fig. G) by disengaging the relevant fasteners (10).
Loosen the side knobs (1, Fig. J) and open the rear shoote by turning it from the position (2) to the position (3).
Carefully lift the hopper (6, Fig. G), by pressing the push-button (43, Fig. D) and the safety push-button (45).
WARNING!
Do not move the machine when the hopper is lifted!
If machine movement with lifted hopper cannot be prevented, be sure to drive slowest possible speed to avoid
lateral instability.
Open the hopper lid (44, Fig. G) with the switch (21, Fig. D); keep the switch pressed until the lid is totally opened.
Carefully dump the hopper (6, Fig. G), by pressing the push-button (40, Fig. D) and the safety push-button (45). Dump the
debris from the hopper.
When the dumping is completed, return the hopper to the horizontal position, by pressing the push-button (39, Fig. D) and the
safety push-button (45).
Lower the hopper (6, Fig. G) completely, by pressing the push-button (44, Fig. D) and the safety push-button (45). Keep the
push-buttons pressed, until the warning light (3) turns off.
If necessary, check for hopper metal fi lter clogging, according to the following procedure:
Engage the parking brake and turn off the engine.
Lift the hopper lid manually and secure it with the support rod (17, Fig. F).
As shown in the Maintenance chapter, remove the fi lters (15 and 12, Fig. F) and check for clogging. If the fi lters are
clogged, clean them according to the relevant procedure. Install the fi lters.
Disengage the support rod (17, Fig. F) and place it in its housing.
Start the engine and close the hopper lid (44, Fig. G) with the switch (21, Fig. D); keep the switch pressed until the warning
light turns off.
The machine is ready to start working again.
1.
2.
3.
4.
5.
6.
7.
•
•
•
•
•
8.
9.
10.
11.
12.
13.
14.
•
•
•
•
15.
16.