28
Service Manual – SW5500, FLOORTEC R 985
03 - General Information
Maintenance
The lifespan of the machine and its maximum operating safety are ensured by correct and regular
maintenance
WARNING: Read carefully the instructions in the Safety chapter before performing any
maintenance procedure.
The following tables provides the scheduled maintenance The intervals shown may vary according to
particular working conditions, which are to be defined by the person in charge of the maintenance.
For instructions on maintenance procedures, see the following paragraphs
Scheduled Maintenance Table (Battery version)
Procedure
Upon
delivery
Every
10
hours
Every
50
hours
Every
100
hours
Every
200
hours
Every
year
Battery charging
(1)
Battery (WET) fluid level check
(2)
Side and main broom height check
Service brake cable adjustment
(3)
Hopper dust filter check and cleaning (“A” method)
(4)
Hopper hydraulic lifting system oil level check
(2)
Skirt height and operation check
Dust guard system water filter check and cleaning
Hopper dust filter check and cleaning (“B” method)
(4)
Filter shaker operation check
Brake adjustment
Nut and screw tightening check
(5)
Steering chain cleaning
Safety system operation check
(2)
Brake pad check/adjustment/replacement
(3)
Hopper dust filter check and cleaning (“C” method)
(4)
Hopper gasket integrity check
Lifted hopper sensor operation check/adjustment
Motor carbon brush check and replacement
Hydraulic system oil change
(6)
(1) Daily or after using the machine
(2) Or before start-up
(3) Or more frequently if the machine is used on slopes
(4) Or more often in dusty areas
(5)
And after the first 8 running-in hours.
(6)
Change the hydraulic system oil for the first time after 500 hours, then every 2,000 hours or every year.
