Nilfisk-Advance 9084312010, Инструкция по эксплуатации

Страница: 65 / 100

INSTRUCTIONS FOR USE ENGLISH
1464020000 - SR 1101 P 15
04/2009
PARKING BRAKE
1. Engage the parking brake by pressing the pedal (3) and engaging the lever (4).
2. Disengage the parking brake by pressing and releasing the pedal (3).
WARNING!
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Engage the parking brake when parking the machine on a slope or incline.
WARNING!
Before leaving the machine unattained, be sure that the parking brake can stop the machine with a large safety
margin.
MACHINE OPERATION
WARNING!
When using the machine on slopes, respect the maximum gradient values marked on the machine itself (see
technical data table).
WARNING!
Pay careful attention when operating the machine at high speed: sudden steering could cause this three-wheel
machine to become unstable due to weight distribution.
Always reduce the speed before steering.
1. Drive the machine to the work area as shown in the previous paragraph.
2. Drive the machine straight forward at a quick walking speed. Drive the machine slower when sweeping large amounts of dust
or debris or when safe operation dictates slower speeds. Overlap passes 10 cm.
3. Avoid stopping for a long time with the machine in the same position and the brooms turning: this could create unwanted signs
on the floor.
4. To collect light and bulky waste materials, lift the front skirt by pressing the pedal (5); take into consideration that the machine
vacuum capability is reduced when the front skirt is lifted.
CAUTION!
When operating on wet floors, it is essential to turn off the vacuum system by pressing the switch (85) to
prevent the dust filter from being damaged.
3. For machine proper operation, the dust filter must be as clean as possible. To clean it while sweeping, turn on the filter shaker
by pressing the switch (85) forward for a few seconds.
During this operation the vacuum fan is automatically shut off.
After cleaning the filter, press the switch (85) backward to restart the vacuum system; then start sweeping again.
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
This procedure can also be performed when the machine is moving.
CAUTION!
When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris any more.
4. The hopper (17) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph).
revised 03/2018