Nilfisk-Advance 56212000, Инструкция по эксплуатации

Страница: 10 / 52

A- 10 - FORM NO. 56041544 - AquaMAX
™
/ AX 650
A-10 / ENGLISH
AFTER USING THE MACHINE
1 Raise the Brush Deck (12) .
2 Turn the Master Key Switch (4) OFF.
3 To empty the solution tank, pull the Solution Drain Hose (21) off the elbow Direct the hose to a designated waste water “DISPOSAL SITE”
and remove the plug. Rinse the tank with clean water. Inspect the solution hoses; replace if kinked or damaged.
4 To empty the recovery tank, take the Recovery Drain Hose (17) off its hanger. Direct the hose to a designated waste water “DISPOSAL
SITE” and remove the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled flow of waste water).
Rinse the tank with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged.
5 Remove the Brush (29) , rinse with warm water and remove any built-up string, hair or carpet fibers.
6 Disconnect the Recovery Hose (24) from the Recovery Tank Dome Lid (2) and flush with warm water to wash any debris out of the Recovery
Hose / Pick-Up Tool Assembly. NOTE: Make sure that you have disconnected the correct hose, if you run water into the vac motors they
will be damaged.
7 Wipe the machine with a damp cloth. Do not use abrasive chemicals or solvents.
8 Perform any required maintenance before storage.
MAINTENANCE SCHEDULE
MAINTENANCE ITEM Daily Weekly Monthly Yearly
Charge Batteries •
Check / Clean Power Brush •
Check / Clean Tanks & Hoses •
Check / Clean Vacuum Shut-Off Float •
Check / Clean Vacuum Motor Filters •
Clean Pick-Up Tools •
Clean Spray Nozzles •
Check Each Battery Cell(s) Water Level •
Inspect Brush Deck Skirt •
Inspect & Clean InLine Pump Filter •
Lubricate the Machine •
* Check Carbon Brushes •
* Have a Nilfisk-Advance service technician check the vacuum motor carbon brushes once a year or after 300 operating hours. The brush and
drive motor carbon brushes check every 500 hours or once a year.
IMPORTANT!
Motor damage resulting from failure to service the carbon brushes is not covered under warranty. See the Limited Warranty State-
ment.
9 Store the machine in a clean, dry place with the tank dome lid open.