Installation
If you are installing the HS-1D into an existing
wall, take time to consider any possible obstruc-
tions which may be hidden inside the wall, such
as wood and metal studs; electrical, telephone or
other types of wiring; plumbing; conduit; old wall
safes; etc.
1.
Install the electrical box or p-ring in the usual
manner.
2.
Run all the necessary wiring to the HS-1D.
Label the wires for future reference.
3.
Make the connections to the HS-1D. Strip
1/4
"
of insulation from the end of each wire . Tightly
twist the end of each wire until there are no
frayed ends. Insert each wire into the appropriate
hole on the connector blocks; secure the wiring to
the connectors by tightening the small connector
screws. Be certain that proper phasing is
observed—connect the positive terminals on the
HS-1D to the positive terminals on the amplifier
and speakers and the negative terminals on the
HS-1D to the negative terminals on the amplifier
and speakers. See
(Figure 3)
.
4.
Secure the HS-1D to the electrical box or p-ring. Insert the
1
1/4
" long device screws into the oblong-shaped screw holes
on the top and bottom of the HS-1D. Note that the oblong
8
H
H
E
E A
A D
D P
P H
H O
O N
N E
E
// S
S
P
P E
E A
A K
K E
E R
R
S
S
E
E L
L E
E C
C T
T O
O R
R
HS-1D
Speakers
Receiver
Figure 3
Wiring Diagram