●
Near other wall controls (see caution below)
DO NOT INSTALL THE HS-1D INTO ELECTRICAL BOXES
WITH 110 VOLT DEVICES.
Some states or municipalities allow devices such as the HS-1D
to be installed into the same electrical box as 110 volt
devices, provided a "low-voltage partition" is used between
the devices. We do not recommend this. Speaker wires can
act as an "antenna" for electrical noise. Locating speaker
wires too close to a light switch or dimmer may cause a
"popping" or "buzzing" sound to be heard through the
speakers. If you must locate the HS-1D near electrical devices,
install it in a separate metal electrical box, ground the box to
the electrical system ground, and route the speaker wires
several feet away from the electrical wiring.
Changing the Color of the HS-1D
The Decora-style insert and button on the HS-1D are remov-
able, allowing fast and easy color changes as needed. Inserts
and buttons are available in a variety of colors.
If you need to change the color of the HS-1D:
1.
Obtain the HS-1D Decora-style insert and button in the
desired color from your Niles dealer.
2.
Holding the HS-1D as shown in
(Figure 1)
, locate the two
plastic mounting tabs at the top rear of the Decora-style
insert. Using two fingers, simultaneously press both tabs
5
H
H
E
E A
A D
D P
P H
H O
O N
N E
E
// S
S
P
P E
E A
A K
K E
E R
R
S
S
E
E L
L E
E C
C T
T O
O R
R
