10
En
Troubleshooting
If the camera cannot establish a strong connection to the PD-10 or if printing suddenly stops, check the following items.
Problem
Possible cause/Solution
The POWER lamp on the PD-10 does not light.
• Use fully-powered batteries.
• Check that the PD-10 is connected to the printer.
Unable to successfully set up the Profile Information on the
camera and PD-10./The camera cannot establish a strong
connection to the PD-10 (overall).
• Check that the printer is on and ready to print.
The camera cannot establish a strong connection to the
PD-10./The connection is interrupted.
The wireless signal may be affected by something nearby. Move the camera and print-
er closer together.
There is a problem with the wireless connection./The con-
nection is interrupted.
The wireless signal may be affected by something nearby. Move the camera and print-
er closer together. Perform a Reset, and then set up the Profile Information on the
camera again (
c
6).
Unable to successfully set up the Profile Information on the
camera and PD-10. (BUSY lamp blinks rapidly in orange.)
Perform Steps 3 and 4 in “Setting Profile Information on the Camera” (
c
6 - 7) in rap-
id succession. In Step 4, the START button must be pressed for two seconds.
Resetting
• If the Reset button is pressed for about one second while the PD-10 is on and connect-
ed to the printer, all of the Profile Information set in the PD-10 will be deleted.
• Press the Reset button with a small, thin object.
BUSY
START
POWE
