
22
10-555 / 10-555-50 / 10-585 / 10-585-50
Setting times
By default, the following times are programmed:
Speech time
after initiating a call
Max. 2'
Time that the
camera image
remains active
80"
Number of times the
red LED
blinks when someone tries to set up a call
while you are keeping the system busy (call or activated camera)
5 times within 10"
Number of times the
red LED
blinks when you pick up the receiver
or activate the camera while the system is busy.
3 times within 6"
Time of indication of a
call
2'
You can also set other times via
• the power supply (see manual of power supply 10-801, 10-802 or 10-806)
• the service unit (see manual of service unit 10-870)
• the relay (see manual of relay)
5. TROUBLESHOOTING
In case of problems, always first check with a multimeter whether the following
voltages
are present:
• between b and a: approx. +24VDC;
• between b and P: approx. +24 VDC;
• between M and P: approx. +24VDC;
• between M and V1 or V2: approx. +5VDC.
A list of possible problems with their causes and remedies is given below.
Problem
Cause
Remedy
You hear a negative tone when
pressing
.
Programming error.
Erase the programming and programme again.
System is still in programming mode.
Exit programming mode.
Video internal unit is not connected
correctly.
Check the wiring.
Two functions assigned to the button.
If a call is in progress, the relay switches to open the door.
If no call is in progress, the light relay switches.
The image on the video internal
unit is not clear.
Conductors V1 and V2 have been
reversed.
Reverse conductors V1 and V2.
Cable is unsuitable:
• cable distance is too great;
• cable is eroded;
• cable cross-section too small;
• cable is not a twisted pair cable.
Replace the current cable with a suitable cable.
The gain on the splitters is not set cor-
rectly.
Adjust the gain on the splitters with the potentiometers.
No image on the video inter-
nal unit. The other functions
work OK.
Wiring is not connected correctly:
• M or P missing;
• V1 or V2 not connected.
Check the wiring (see wiring diagram).
Jumpers not configured correctly.
Set the jumpers correctly on the contacts (see chapter Installation)
No voice on the video internal
unit. Only the image is dis-
played.
Wiring is not connected correctly.
Check the wiring (see wiring diagram).
EN