c. Side view with installation order (fig.7)
front plate
back plate spring
distance nut
camera module
fixing plate
nut washers
fig.7
Install the camera module as follows:
- Separate front and back plate.
- Place the front plate before the mounting opening and insert the screw threads.
- Place the back plate back on the front plate so the fixing plate is clasped between both
plates. Fix the surround plate to the mounting plate by screwing down a nut over each of
the 4 screw theads.
- Then, over each of the 4 screw threads, successively screw down a washer, a spring and a
washer again.
- Place the mounting holes of the camera module over the screw threads (see also fig.6).
- Then tighten the 4 distance nuts on the screw threads (the short distance nut should be
located there where the cover at the back of the camera module is the thinnest). Thanks to
the springs, you can adjust the position of the camera yourself.
- Tighten or slightly untighten the distance nuts to fix the camera closer resp. further away
from the front plate.
10-496 / 10-497 / 10-896 / 10-896-10
22
