4
CHARGING INSTRUCTIONS
SAFETY
1)
Our range of electric bikes are only designed to be charged by our supplied
battery chargers, either the Sans 2A or 3A charger.
2)
Prior to re-charging ensure that the charging environment is suitable. A
suitable area would be an undercover, well-ventilated area.
3)
If you notice any unusual smell or noise while charging, stop charging and
investigate the issue.
RECHARGING WHILST CONNECTED TO THE BIKE
1)
Ensure that the bicycle is turned off and remove the ignition key.
To connect the charger
2)
Firstly, connect the output socket from the battery charger to the socket on the
battery pack. Secondly, connect the input socket with the wall socket. Thirdly,
turn on the power for the wall socket. Finally, check that the charger light is
illuminated, initially the light should be green and then switch to red, which
means the battery is charging.
3)
Once the battery is fully charged the red light will switch to green. The green
light is a trickle charge. Therefore, it is strongly advised that the battery pack
is not charged for in excess of 2 hours after the green light has illuminated, to
maximise the longevity of the battery pack.
To disconnect the charger
4)
Firstly, turn off the power from the wall socket. Secondly, disconnect the
output socket from the battery charger to the socket on the battery pack.
Thirdly, disconnect the input socket from the wall socket. Finally, store the
charger in a dry area, ideally within a box such as the supplied box.
RECHARGING WHILST REMOVED FROM THE BICYCLE
1)
Ensure that the bicycle is turned off.
To remove the battery pack
2)
Firstly, unlock the battery pack with the ignition key. Release the lever under
the saddle, then rotate the saddle from the horizontal to vertical position. Lift
the battery pack vertically until the battery pack clears the saddle.
