3
PRE-RIDE SAFETY CHECK
Check:
•
The battery is fully charged and secured;
•
The folding mechanism, handlebars, saddle, front and rear wheel fastenings
are secured;
•
Tyres are inflated to the correct pressure;
•
Front and rear brakes; and
•
The chain has tension and has suitable lubrication.
RIDING INSTRUCTIONS
RIDING
1)
Turn on the ignition switch to “ON” and press the power switch for the LCD
display;
2)
Ensure that the power assistance level on the LCD display is set to either ‘1’
or ‘2’ (as a low level of assistance is adequate to commence cycling).
3)
Ensure the kickstand is raised, start pedaling and the power assistance will
gradually begin to assist the rider. Once at your chosen speed, adjust the
power assistance to suit;
4)
Alternatively, the use of the thumb throttle can assist the rider up to 6KPH
whilst pedaling;
5)
The brakes are fitted with power cut-off, which means that when the brake
lever is activated the motor will automatically disengage.
Special note: It is highly recommended to pedal whilst starting or climbing steep hills.
This will assist the service life of the battery and motor.
PARKING
Ensure the bicycle has been parked on level ground. Turn the power assistance to 0,
switch off the LCD display and turn the ignition key to off.
Special note: It is highly recommended that the bicycle is not stored in direct sunlight,
as long-term, this may damage electrical components on the bike.
