SWISS MADE
MODE
SET
SWISS MADE
MODE
SET
ＣＲ２０３２
＋
IP65 class waterproof rating
Small size
ABS and REL measurement modes
ABS mode: With Display Hold
REL mode: With one touch Preset recall
Direction of measurement (
＋
/
−
) switchable
Preset function
Auto-off feature (approx. 4 hour)
※
REL mode only
Made in Switzerland
●
●
●
●
●
●
●
LCD Display
[SET] Button
Stem
(Mounting Shaft)
Spindle
Contact Point
[MODE] Button
Battery Cover
Model No. DEI-233S1/DEI-233S2 <combined>
Thank you for purchasing the Digital S-Line Indicator.
For proper operation, please read this manual thoroughly before use.
DIGITAL S-LINE INDICATOR
（
IP65
）
Accessories
ＣＲ２０３２
CR2032
(Lithium Cell)
※
Included for test
FEATURES
BATTERY REPLACEMENT
①
Remove the (2x) battery screws using (+) PH#0
screwdriver. Place a small standard screwdriver in
the notch to gently pry open the cover and slide out
the battery.
②
Insert the new battery following the polarity markings
on the cover.
③
Replace Battery Cover and tighten screws to secure.
SPECIFICATIONS
YES
φ
8mm
70g
5
〜
40
℃
CR2032(Lithium cell)
×
1
DEI-233S1
0.001mm
0.01mm
0.01mm
0.01mm/0.001mm
(switchable)
0.02mm
0.002mm
up to
±
130mm
0-12.5mm
Less than 1.5N
0.005mm
DEI-233S2
Model No.
Measurement Range
Resolution
Displayed Resolution
Accuracy
Measurement Force
Repeatability
Preset
Measurement Dir. Switchable
Mounting Shaft Diameter
Operating Temp. Range
Power Supply
Weight
Battery
Battery Cover
Battery Cover
Notch
PARTS IDENTIFICATION
NOTICE
Use only CR2032 type battery.
See Reverse for
“
How to Use
”→
TROUBLESHOOTING
Error Condition
Corrective Action
Measured value is
wrong
Clean measuring surfaces with lens
tissue or similar.
Confirm and re-set 0-Point setting.
●
●
LCD does not
display
Displayed value is
unstable
Display is hard to
read
●
●
●
Cycle power by removing and
replacing battery.
Replace battery with new one.
●
●
※
If problem persists, or if you have any questions, please contact distributor
or place of purchase.
※
Please note, manufacturer is unable to respond to inquires or provide
service directly. Please contact distributor or place of purchase.
Read Error.
Reset the sensor by pressing the
[MODE] or [SET] button.
※
If message is displayed again, there
is possibility that the memory is
corrupted; Please contact distributor
or place of purchase.
“
Err 0
”
is Displayed
on LCD
INSTRUCTION MANUAL
