NightWatcher SWNW520, Инструкция по использованию и уходу

Страница: 6 / 9

6
Operation
1
Detection range
2
Function
□
This light is equipped with three motion sensors:
zone1 covers 60 degrees, zone 2 covers 100
degrees and zone 3 covers 60 degrees. There is a
220 degree maximum total in all three zones.
□
When power is first turned on the light will go to
self-calibration mode for about 1 minute.
□
During calibration mode the light will switch on
for 1 minute to test bulb activity.
□
If calibration was done during day time the
light will automatically go to stand-by mode
until dusk.
□
If calibration was done during night time the
light will resume normal operation.
□
The factory default setting is:
□
Night Mode: the light will turn on for 3
minutes when heat/movement is detected
through the front lens of the motion
detectors.
□
To change detection/light activity to ALL Day
Mode, push the button at the bottom of the
housing.
3
Programmable functions
4
Reset function
NOTE:
The hidden LED indicator will be constantly red in Night
Mode. The hidden LED indicator will stay off in ALL Day
Mode.
□
Programmable Functions:
□
Night Mode: light works at night only (factory
default setting)
□
ALL Day Mode: light works day and night
Mode Button
□
Fixed Light Mode: allows the unit to function as a
traditional motion activated flood light where the
light head will not move. Press the mode button for
3 seconds, the hidden LED will flash RED in a quick
flash pattern. To exit this mode, press the mode
button for 3 seconds.
□
If the tracking light motor malfunctions, the
hidden LED indicator will flash red and the
light will stop turning automatically.
□
In ALL Day Mode, the red light will flash on
and off for 5 seconds; in Night Mode, the red
light will flash in regular patterns.
□
If the motor malfunctions, simply switch off
and on at the main power supply to reset the
tracking light operation. Below are the
possible causes of the malfunction:
- External force: the light head is blocked by
objects or is blown by strong wind and is
unable to turn properly. The hidden LED will
flash red to signal the malfunction.
□
- Tracking light motor: when the motor is out
of synchronization, malfunctions, or is
damaged, the hidden LED will flash red to
signal the abnormal situation. Switch off and
on at the main power supply. If the motor
stops working, the unit can still be used as a
regular (fixed) motion sensor security light.