Nidek Medical LE-700, Руководство по установке, Страница: 67 / 80

61
CHECK AND ADJUSTMENT PROCEDURES: Groove Position Check and Adjustment
3.12 Groove Position Check and Adjustment

Move the groove position of the auto-processed lens to the desired position.
3.12.1 Groove position check
1
Enter service mode from the LE-700 home screen.

“3.2.1 Entering service mode” (page 20) - (Step 6)
2
Press the “Maintenance” tab.
The maintenance screen appears.
3
Press Circle 45 .
The processing condition screen appears.
4
Specify the grooving conditions.
1)
Set each item as follows:
“Material” → CR39
“Type” → Single
“Frame” → Groove
“Groove position” → Auto
“Soft” → None
“Polish” → None
“Layout” → Passive
“FC” → None
2)
Press .
The layout screen appears.
5
Continue the processing method on the layout screen using the same procedures
explained by the following steps starting from size setting.

“3.5.1 Size check” (page 27) - (Step 5) to (Step 10)
CAUTION
• The following procedure is to change the position of an auto-processed groove according to the
user’s needs. Do not perform this procedure to correct deviation of the bevel position from the spec-
ified settings. If such an adjustment is found to be required during installation, refer to Service Man-
ual for further details.