32
PARAMETER-SETTING INTERFACE AND OPTIONS
POWERDRIVE MD2R Installation guide
4948 - 2017.11 / d
en
5.1.2 - MDX-Powerscreen
• General
The POWERSCREEN interface is a touch screen which can
be used to access various menus to setup and supervise the
drive. It is installed as standard on the
POWERDRIVE MD2R.
After the loading phase following the power-up of the drive,
the parameter-setting interface displays the screen below in
french. Select language using the "F" buttons below
COM
CPU
PWR
F
C
D
E
A
B
Ref.
Function
A
4.3" touch screen
B
Touch-sensitive button to access the main menu
C
"COM" LED, indicates the state of the communication
with the drive.
Off: no communication
Flashing: communicating
D
"CPU" LED, indicates the status of the interface CPU
E
"PWR" LED, indicates the state of the interface power
supply
F
Touch-sensitive buttons for language selection (can take
a few minutes to load)
5 - PARAMETER-SETTING INTERFACE AND OPTIONS
POWERDRIVE MD2R
includes two control modules :
•
A module for actif rectifier.
• A module for motor inverter.
The HMI is connected to the motor inverter module, but it can
be connected to the active rectifier module for its initial setup
(P2 connector of the active rectifier control board).
5.1 - Parameter setting interfaces
5.1.1 - Location of the drive connectors / ports
Px1
Px2
Px3
P1 P2
1
1
1
Connector for optional
fieldbus and/or
speed feeback
Connector for
MDX-Powerscreen display
USB connector linked
to door USB socket
◦ P1 connector
This connector is a slave type B USB connector linked to door
USB socket, and is used to communicate via PC using the
MDX-SOFT software.
In conformity with standard EN 60950, the USB link
can only be used via a device that provides
isolation of 4 kV (MDX-USB isolator option).
◦ P2 terminal block
This is a standard RS485/RS422 terminal block which is used
to connect a parameter-setting interface (MDX Powerscreen,
MDX Keypad) or to communicate via Modbus RTU.
Terminals
Description
1
0V
2
Rx\, Tx\
3
Rx, Tx
4
24V
Check that control circuits are powered down
before disconnecting the programming interface
from the P2 connector.
