Nicols PARLED 1412 FC IP, Руководство пользователя

Страница: 9 / 14

SAFETY INSTRUCTIONS
1.
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this
instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability
for any resulting defects or problems
.

Unpack and check carefully that there is no transportation damage before using the unit.

The unit is for indoor use only. Use only in a dry location.

DO install and operate by qualified operator.

DO NOT allow children to operate the fixture.

Use safety chain when fixing the unit. Handle the unit by carrying its base instead of head only.

The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.

Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.

Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.

It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.

Maximum ambient temperature Ta: 40
℃
. DO NOT operate it when the temperature is higher.

DO NOT connect the device to any dimmer pack.

During initial start-up some smoke or smell may arise. This is a normal process and does not necessarily mean that the
device is defective, and it will decrease gradually within 15 minutes.

Make sure there are no flammable materials close to the unit while operating to avoid fire hazard.

Examine the power wires carefully, replace them immediately if there is any damage.

Unit’s surface temperature may reach up to 85 ℃ . DO NOT touch the housing bare-handed during its operation, and allow
about 15 minutes for cooling the unit down before replacing bulb or maintenance as it could be very hot.

Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens, cut off the mains power
immediately.

DO NOT operate in dirty or dusty environment, do clean fixtures regularly.

DO NOT touch any wire during operation as there might be a hazard of electric shock.

Avoid power wires together twist other cables.

The minimum distance between light output and the illuminated surface must be more than 12 meters.

Disconnect mains power before fuse/lamp replacement or servicing.
Please read carefully the instruction, which includes important information about the installation,
usage and maintenance.