GB
5
1.
Press and hold the programming pushbutton
2.
Wait for the led to illuminate, then wait for it to turn off, followed by a flashing sequence.
3.
Release the pushbutton precisely
during the third flash
to delete the memorized
transformers only, or
during the fifth flash
to delete the entire contents of the
memory.
4.
If the memory clearing procedure has been successful, the led will flash 5 times.
Table “A4”
Memory deletion
Example
The type of code can be checked by the number of flashes emitted by the led on start-up.
Led flashes
Code type of memorized transmitters
1 short flash (total 0.2s)
Transmitters with FLO code
2 short flashes (total 0.4s)
Transmitters with FLOR code
3 short flashes (total 0,6s)
Transmitters with SMILO code
2 long flashes (total 1.5s)
Memory empty (no transmitter memorized)
FLO4R
VERY
SM4
SM2
4.1) Compatible transmitters
Table A5 indicates the transmitters and relative type of code that can
be used with the TT2L and TT2D control units.
Because the coding of the transmitters is different and the control unit is unable to recognise them at the same time, the first transmitter
memorized determines the type of coding in use and therefore the type of transmitters that can be memorized afterwards. If it is necessary
to change the type of transmitter after the first transmitter has been memorized, all transmitters must be cleared (see table A4).
Coding
Transmitters
ERGO1 - ERGO4 - ERGO6
PLANO1 - PLANO4 - PLANO6 - PLANO TIME
FLOR
Rolling code FLO1R - FLO2R - FLO4R
NICEWAY
VERY VR
SMILO Rolling code SM2 - SM4
FLO
Fixed code
FLO1 - FLO2 - FLO4
VERY VE
Table “A5”
ERGO
PLANO
NICEWAY
1.
Press and hold down the programming button for at least 4 seconds.
2.
Release the programming button when the LED lights up.
3.
Within 10 seconds, press and hold down for at least 3 seconds key 1 0r 2 (or key 3 or 4)
of the transmitter to be memorized.
4.
If the memorization procedure is successful, the led emits 3 long flashes.
Note.
If there are other transmitters to be memorized, repeat point 3 within a further 10 seconds; the memorization phase terminates if no
new transmitters are received within a 10 second interval.
Table “A3”
Memorizing of a transmitter in mode I
Example
4s
3s
(
)
3.2) Settings via the programming pushbutton
To memorize a transmitter via the programming pushbutton proceed as described below.
If you need to clear the memorization and programming operations, follow the steps described below.
4) Additional information
In addition to the FLO2R, VERY VR and NICEWAY series transmitters, the TT2L and TT2D control units also recognise other transmitters
produced by Nice (paragraph 4.1 Compatible transmitters). A particular command can also be associated to each transmitter key by means
of a specific memorization procedure (paragraphes 4.2.1 Mode I and 4.2.2 Mode II).
4.2) Memorization of the transmitters in Mode I and Mode II
Tables A1, A2 and A3 describe the memorization of the transmitters in Mode I, where a pair of keys is used on each transmitter: 1-2 or 3-4.
The transmitters can also be memorized on the TT2L and TT2D using Mode II, which allows greater flexibility in the use of the transmitter
keys. Transmitters can be memorized using both Mode I and Mode II on the same control unit.
