English –
15
Symbol
Description
on the control unit, select the OPEN + CLOSE
buttons
on the control unit, select the OPEN + STOP but-
tons (SET)
on the control unit, select the STOP (SET) +
CLOSE buttons
I
O
I
O
PROG selector = default location
I
O
I
O
move the PROG selector to the left = position
I
I
O
I
O
move the PROG selector to the right = position
0
device acquisition phase
Symbol
Description
position acquisition phase
move the garage door to the halfway position
Clik
release and lock the gearmotor
closing-opening-closing
end of procedure
5.1 - Control unit quick set-up
The ‘Control unit quick set-up’ function allows for speeding up the motor’s commissioning.
It only works with virgin memory.
After the initial flashing of the LEDs, the control unit waits for the acquisition of the devices by making L1 + L2 flash slowly. Control unit quick
set-up only starts with the PROG selector to the right (
I
O
I
O
)
If you use a category B resistive sensitive edge (according to EN13849-1, -2) to limit the impact force (according to CAT 2 and Performance Level
C), you must activate parameter L5 (level one programming) and then perform the device search procedure.
Memorisation procedure
01.
02.
03.
ON
I
O
I
O
(OPEN+CLOSE) 10 s
L3
=
(OPEN+CLOSE)
I
O
I
O
5 s
Clik
04.
05.
06.
07.
Clik
L1 + L2
(5-15 s)
CAUTION! - If, in the next step, the first manoeuvre to be car-
ried out is an Opening manoeuvre, interrupt the position acquisi-
tion and invert – on the control unit – the electrical connections
on the motor terminal. Repeat the procedure from point 1.
08.
L3 + L4
=
09.
=
