7
– English
A.7 - Adjusting the Soft-Start / Soft-Stop movement
NOTES AND WARNINGS
• This procedure can be used to activate, adjust or deactivate the Soft-Start / Soft-Stop movement.
• The following options are available:
–
function DEACTIVATED
–
1/2 turn
–
3/4 turn
–
1 turn
–
1,5 turns
The motor slows down for the number of set turns during both the start and stop phases
1
2
2
...
?
...
3
Hold down both buttons...
count 2 movements;
wait without releasing
the two buttons...
count 3 movements;
immediately
release only button
s
; but-
ton
t
must remain pressed.
2
3
continues
(x
4
)
...
?
...
4
Select the desired option and pro-
gram it as follows
Press and release the key.
wait for the motor to complete 4 movements;
3
3
end
(x
...
)
5 OPTIONS:
1 press
=
DEACTIVATED
2 presses
=
Level 2
(1/2 turn) (Default)
3 presses
=
Level 3
(3/4 turn)
4 presses
=
Level 4
(1 turn)
5 presses
=
Level 5
(1,5 turns)
...
?
...
?
1
/
2
/
3
/
4
/
Press and release the button
the number of times
indicated in the
option you have chosen.
wait for the motor to perform a number of
move-
ments
equal to the number of pulses entered;
also release button
t
.
A.8 - TOTAL or PARTIAL deletion of memory
A.8.1 - TOTAL memory deletion
NOTES AND WARNINGS
• If during the execution of the procedure you choose the option “5 presses = clear ALL MEMORY”, the system restores the factory settings by clearing the “0” and
“1” limit switch heights and all other data stored in the memory of the motor.
• If during the execution of the procedure you choose the option “5 presses = clear ALL MEMORY”, subsequently, during the use of the automated system, when you
command an Up or Down manoeuvre the roller shutter first performs
2 movements (START & STOP)
(= no limit switch is programmed) and then continues the
commanded manoeuvre.
1
2
3
=
3
sec
2
• If you want to delete
all the memory of the motor
,
move the roller shutter to a half-way position.
Hold down both buttons...
count 2 movements;
immediately
release only button
t
;
button
s
must remain pressed.
3
4
end
(x
5
)
3
sec.
2
Press and release
the key.
After about 3 seconds the movement is
briefly interrupted 2 times;
also release button
s
.
A.8.2 - PARTIAL memory deletion
NOTES AND WARNINGS
• If during the execution of the procedure you choose the option “3 presses”, subsequently, during the use of the automated system, when you command an Up or
