the menu being set comes to an end, the next LEARN pulse will
return the menu to the home position.
1. Check that the gate is engaged. If not, engage it.
2. After recording the control, make sure that the (tilting drive nut) is
between the limit switches, or on top of any of them with their respec
-
tive (limit switch) LED on, and the stops well adjusted.
3. If the limit switches are already in the correct positions just go to
index 4, otherwise if the limit switches are not already adjusted follow
the steps below:
Turn the PROG switch to the position as shown below:
• Activate the previously recorded remote control, the control unit will
operate normally only at low speed and without recording path or
torque.
ATTENTION!
•
If the engine direction is wrong, the control unit will touch the stop
and adjust the direction automatically, so always leave the stops ad-
justed.
• After the limit switch adjustment is complete, turn the PROG swit-
ch to the (OFF) position, and press the previously recorded remote
control.
NOTE: During learning, the control unit automatically identifies whe
-
ther or not the machine has a limit switch.
After learning the path and torque, the panel learns the parameters of
the motor that was installed, that is, if you wanted to install the panel
on another motor, it is necessary to RESET the panel according to
the index 35.
Each time the switch is reset, it will do the learning again.
• The switch must find the opening limit switch to start learning, the
opening limit switch is the first limit switch triggered during the limit
switch setting process.
• After finding the opening limit correctly, the switch will start the lear
-
ning cycle according to the sequence below.
72
ENGLISH
