English –
2
EN
•
Be careful with moving shutters and keep away from them until they have lowered fully
•
Be careful when activating the manual release device, as a raised shutter may rapidly drop in case of weak or broken springs
•
Do not activate the awning when maintenance activities – such as window cleaning – are being carried out nearby
•
Disconnect the awning from the power supply when maintenance activities – such as window cleaning – are being carried out nearby. Warning for ‘shades with
automatic control’
INSTALLATION WARNINGS
•
Prior to installing the drive motor, remove any unnecessary cables and disable any appliance not required for motorised operation
•
Install the manoeuvring assembly for manual release at a height below 1.8 m
NOTE: if removable, the manoeuvring assembly must be kept close to the door
•
Make sure that the control devices are kept far from moving parts but nonetheless in a visible position. Unless a selector is used, the control devices must be
installed at a height of at least 1.5 m and must not be accessible
•
The fixed control devices must be installed in a visible position
•
For drive motors that allow for accessing unprotected moving parts once they have been installed, such parts must be installed 2.5 m above the floor or other
surface form which they can be accessed
1
PRODUCT DESCRIPTION AND INTENDED USE
This product is a tubular motor designed for the automation of a shutter, sun awning or solar screen.
CAUTION! – All uses other than the intended use described and use in environmental conditions other than those described in this manual
should be considered improper and forbidden!
The product has the following features:
– designed to move the shutter in Ascent and Descent, the model is also equipped with a mechanism for emergency manual manoeuvres, for use in the event of
a power failure;
– is equipped with an electromechanical system that automatically shuts off power supply when the shutter reaches the set limit positions: position “
0
” (shutter
totally retracted) and position “
1
” (shutter totally extended);
– install inside the winding roller; the part of the motor that protrudes from the roller (electronic head) is fixed to the ceiling or the wall with suitable support brack-
ets (not supplied in pack);
– it is designed for residential use, i.e. discontinuous. It guarantees a continuous operating time of maximum 4 minutes;
– it is fitted with a thermal cut-out which in the event of overheating due to use of the automation in excess of the set limits, automatically shuts off the power sup-
ply and only restores operation when the temperature returns within the normal range.
