7
– English
7
– English
–– GROUP “A” PROCEDURES ––
Procedures which can only be completed using a Z-Wave gateway
A.1 - Adding the device to the Z-Wave network
NOTES AND WARNINGS
•
If the adding process is unsuccessful, perform the removing procedure (A.2), then repeat the adding procedure again.
A.1.1 - Adding manually
1
2
3
4
ON
(x
3
)
Connect the electrical pow-
er supply to the motor.
Set the Z-Wave gateway in-
to adding mode (see the Z-
Wave gateway’s manual).
On the motor head:
press and release ei-
ther of the two buttons (
3 times
);
the
green led
starts flashing quickly.
4
5
end
DSK: XXXXX-XXXXX-XXXXX-XXXXX
XXXXX-XXXXX-XXXXX-XXXXX
...
Only If you are adding in the Security S2
Authenticated mode:
input the underlined
part of the DSK (label on the box)
Wait ...
If adding is successful:
the light turns
solid green
for
3 seconds
;
If adding is unsuccessful:
the light turns
solid red
for
3 seconds
,
then starts
flashing green
slowly.
A.1.2 - Adding using SmartStart
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with a gateway providing SmartStart in-
clusion. SmartStart product will be added automatically within 10 minutes of being switched on in the network range.
1
2
3
4
5
DSK: XXXXX-XXXXX-XXXXX-XXXXX
XXXXX-XXXXX-XXXXX-XXXXX
ON
If your Z-Wave gateway supports
SmartStart, set it into Security S2 Au-
thenticated add mode (see the Z-Wave
gateway’s manual).
Enter the full DSK string code to your Z-
Wave gateway. If your controller is capable
of QR scanning, scan the QR code (label on
the box).
Connect the electrical pow-
er supply to the motor.
The
green led
starts flashing quickly,
when the adding process starts.
5
end
...
Wait ...
If adding is successful:
the light turns
solid green
for
3 seconds
;
If adding is unsuccessful:
the light turns
solid red
for
3 seconds
,
then starts
flashing green
slowly.
A
