GB
16
Installing the control box
The plug and control box are threaded out through the knockout in the rear of the stove. Install the control box on the wall at a suitable
height. Connect the plug only when the fan is fully installed.
Operating
Connect the plug to the mains. The fan control box has eight positions.
Position (0) = The fan is completely switched off.
Position (1-4 Auto) = Four different speeds for the fan to start and stop automatically when the stove becomes hot or cold.
Position (1-3 Man) = The fan is controlled manually with three speeds.
Automatic control
The fan uses a control module to start and stop the fan automatically. It functions as follows:
The fan starts when it is approximately time for the first addition of firewood, this occurs approximately 25 minutes after the fire is lit (read
lighting instructions). When the fire is dying the fan stops approximately 2 hours after the fire has turned to embers. The fan uses the heat
that the stove produces and circulates it around the room efficiently. This means that the fan may restart a couple of times before it stops
completely. If the stove is already warm and the switch is turned to “auto” the fan needs a few minutes to sense the heat of the stove before
it starts. The times can vary depending on the amount and type of wood. For example, dry wood starts more quickly and a large bed of embers
takes longer to cool.
In the event of running problems the control module can be reset to correct the problem. This is done by pulling the plug out and recon-
necting it after approximately 15 minutes.
Technical specifications
Power supply: 230V 50Hz Output: 40W
Contura reserves the right to change
dimensions and procedures described in these
instructions at any time without special notice.
The current edition can be downloaded from
www.contura.eu
NIBE AB · Box 134 · SE-285 23 Markaryd
www.contura.eu
511498 MAV Fläkt C600-7
2018-09-06
Содержание Flakt Contura C600
Страница 2: ......
