Nibe FIGHTER 1310, Инструкция по установке и обслуживанию

Страница: 12 / 52

Control, normal
FIGHTER 1310
For Home Owners
10
Available information and on-display settings
NOTE!
Enter the chosen settings in the table
on page 2 of this manual. The details
are important for
service work.
HP start A
Shows the total number of starts of heat pump
module A.
HP start B
Shows the total number of starts of heat pump
module B.
HP-time A
Shows the total number running hours for heat
pump module A.
HP-time B
Shows the total number of running hours for heat
pump module B.
English
[P]
Chosen language setting. Press Increase to
change language. When you have chosen the
required language, press the Channel button.
Channel 1 re-appears.
A HP on
Successively shows the following operating sta-
tuses: HP off, HP on, HP start in X minutes or
High return temp for module A or B respectively.
6
7
8
5c
This menu is a submenu to menu 5 (or 5b). It is
activated by placing the cursor under the value
for Curve slope (or Room-comp if a room sensor
is connected) and pressing the Channel button.
WW-out min
[P]
Setting for the minimum calculated flow line
temperature.
Setting range: 10 - 50 °C.
Preset value: 15 °C
WW-out max
[P] Setting for the maximum calculated flow line
temperature.
Setting range: 30 - 70 °C.
Preset value is 55 °C.
The heating water flow temperature may tem-
porarily go above or below the setting as a result
of normal fluctuations.
For example, for underfloor heating with floating
condensation, suitable settings might be min
20 °C, max 40 °C.
With fixed condensation, the same setting is cho-
sen for the minimum and maximum levels. (Sen-
sor location, temperature setting and pump flow
are taken into account.)
WW-out min 15 °C
WW-out max 55 °C
HP start A 10
HP start B 4
English 0
A HP on
HP-time A 40 h
HP-time B 10 h