- 23 -
5.4
PUTTING INTO OPERATION
Before starting, check whether the installation is set up according to the recommendations and that
everything is in conformity, then you may plug your equipment to the power supply.
After switching on your equipment, you should wait a few seconds until the controller begins to work.
Then you may start your equipment following these instructions:
Note 1:
The LED on the display indicates the status of your equipment. When is blinking means that your
equipment don’t have any order to work, if the LED is ON and no blinking, your system is working with the
order that was given.
Note 2:
To restart the appliance, switch it off and switch on again using the key ON/OFF.
5.5
OPERATING MODES
The AQUA HP is programmed to work in 3 main running modes:
ECO, AUTO, BOOST
. The equipment can also
work in
LAT
(protection of the compressor) and
TCC
(alternative energy source).
Mode
Symbol
Function
ECO
Normal running as Heat Pump
AUTO
Optimized management of running of Heat Pump and/or
Electrical Heater (backup)
BOOST
Running of Heat Pump + Electrical Heater (backup)
LAT
Running of Electrical Heater ( Fan
TCC
Running of Heat Pump + Electrical Heater (backup)
Press key
COMP
to start
up the system
System is shut
OFF
Press key
ON/OFF
Controller ON
