GB
10
Automatic device
The fan uses a control module to start and stop the fan
automatically. It functions as follows:
The fan starts when it is approximately time for the first
addition of firewood, this occurs approximately 25 minutes
after the fire is lit (read lighting instructions). When the fire
is dying the fan stops approximately 2 hours after the fire
has turned to embers. The fan uses the heat that the stove
produces and circulates it around the room efficiently. This
means that the fan may stop and restart a couple of times
before it stops completely. If the stove is already warm and
the switch is turned to “auto” the fan needs a few minutes to
sense the heat of the stove before it starts. The times can
vary depending on the amount and type of wood. For example,
dry wood starts more quickly and a large bed of embers takes
longer to cool.
In the event of running problems the control module can be
reset to correct the problem. This is done by pulling the plug
out and reconnecting it after approximately 15 minutes.
Technical specifications
Power supply: 230V 50Hz Output: 40W
Installing the control box
The plug and control box are threaded out through the
knockout in the rear of the stove. Install the control box on
the wall at a suitable height. Connect the plug only when the
fan is fully installed.
Operating
Connect the plug to the mains.
The fan control box has eight positions.
Mode (0) = The fan is completely switched off.
Mode (1-4 Auto) = Four different speeds when the fan starts
and stops automatically when the stove becomes hot or cold.
Mode (1-3 Man) = The fan is controlled manually with three
speeds.
Remove the inner screw on the plate at the grate control.
Secure the temperature sensor in the hole using the M6X20
screw supplied.
The temperature sensor must only be
attached using cable terminals. Impacts
on the cable sheath are potentially lethal.
!
C500 Style
C500 Style (Before 2019)
C600 Style
