Nibe AXC 50, Руководство по установке

Страница: 25 / 48

DIP switch
The DIP switch on the accessory card must be set as fol-
lows.
ON
12345678
ON
12345678
-X9
-X2
24 20 21 22 23 15 16 17 18 19 10 11 12 13 14 5 6 7 8 9 1
1
N
L
PE
PE
1
2
3
4
5
6
7
8
2
3
4
5
6
7
8
9
2 3 4
-X8
-X4
-X10
-X1
$$6
Program settings
Program setting of AXC 50 can be performed via the start
guide or directly in the menu system.
Start guide
The start guide appears upon first start-up after heat
pump installation, but is also found in menu 5.7.
Menu system
If you do not make all settings via the start guide or need
to change any of the settings, this can be done in the
menu system.
Menu 5.2.4 - accessories
Activating/deactivating of accessories.
Select: "hot water comfort".
Menu 2.9.2 - hot water recirc.
Here you can make the following settings for hot water
circulation for up to three periods per day:
႑
How long the hot water circulation pump must run per
operating instance
႑
How long the hot water circulation pump must be
stationary between operating instances.
Menu 5.3.8 - hot water comfort
Here you can perform the following settings:
႑
If an immersion heater is installed in the tank and
whether it can be permitted to charge hot water if the
compressors in the heat pump prioritise heating.
႑
Whether a mixing valve for limiting the temperature of
hot water from the water heater is installed.
႑ Various shunt settings and outgoing hot water temper-
ature from the tank for the mixing valve.
Menu 5.6 - forced control
Forced control of the different components in the heat
pump as well as in the different accessories that may be
connected.
QZ1-AA5-K1: Activating the relay for extra hot water.
QZ1-AA5-K2: Signal (close) to the mixing valve (FQ1).
QZ1-AA5-K3: Signal (open) to the mixing valve (FQ1).
QZ1-AA5-K4: Activating the circulation pump (GP11).
Caution
Also see the Operating manual for F1345.
23 Chapter 6 | Hot water comfort AXC 50