19
We reserve the right to make technical changes
83054206bUK – Translation of the operating manual
NIBE
TM
AP-AW30
•
All electric installation work must be properly
completed.
•
A
3-pole automatic circuit-breaker
must
be installed for the compressor. It must have a
contact gap of at least 3 mm.
•
The heating circuit must be rinsed, filled and
thoroughly bled.
•
All valves and shut-off devices of the heating
circuit must be open.
•
All pipe systems and components of the system
must be sealed.
The heat pump system will be commissioned by
customer service personnel authorized by the
manufacturer. There is a fee for commissioning!
safety temperature limiter
A safety temperature limiter is built into the electric
heating element (depending on model). In the event of a
malfunction in the heat pump or air in the system, check
whether the reset button of the safety temperature lim-
iter has tripped. If this is the case, push in the button.
1 Safety temperature button on
electric heating element
2 Reset button
Dismantling
Danger!
Danger of fatal injury due to electric
current!
electrical connections may be installed
only by qualified electricians.
Before opening the unit, disconnect the
system from the power supply and secure
it from being switched back on!
WarnIng!
only qualified heating or cooling system
technicians are allowed to remove the unit
from the system.
attentIon
Recycle or provide for proper disposal of unit
components, refrigerants and oil in accordance
with the applicable regulations, standards and di-
rectives.
remoVal of the buffer battery
attentIon
before scrapping the heating and heat pump reg-
ulator, remove the buffer battery on the proces-
sor board. The battery can be pushed out using
a screwdriver. dispose of battery and electronic
components in keeping with environmental con-
siderations.
