Nibco RHP-1, Инструкция по установке и эксплуатации

Страница: 6 / 29

Installation and Operation Manual Radiant Heat Panel
6
RHP-1&2 0511
Thank you for purchasing a NIBCO
®
Radiant Heat Panel. The RHP unit is the easiest way to link a
properly sized heat source to the radiant system using time tested control technology. Backed by years
of experience designing components for the heating industry, the NIBCO
®
RHP is a reliable choice
for radiant system control.
Features: Benefits:
Pre-engineered Designed for Dependable Performance using Proven Components
Pre-assembled Tested for Installation Leak Free Consistency.
Pre-wired Facilitates Quick Trouble Free Start Ups.
Compact Minimal area needed for installation.
Modular Systems of any size can be assembled.
Warranty 12 months from purchase.
The RHP-1 model will serve up to five loops. The RHP-2 model will serve up to ten loops.
Each loop is capable of handling no more than 0.5 USgpm.
Each loop is to be
½
” PEX (or BARRIER-PEX).
Each loop is not to exceed 250 ft.
The RHP moves heated fluid to the Radiant Floor Heating (RFH) system and allow you to raise or lower
the room temperature. As long as the circulator is moving water according to instructions from the
thermostat, the RHP is operating as intended.
The delivery of heat to your floor and room is based on the temperature of the fluid, the capacity of
the RHP circulator and design of the RFH. Restriction to water flow such as the radiant floor heating
pipes in your floor, temperature of the heated water, and the design/installation of your RFH system
will have an impact on the system. Most RFH systems need a minimum of 110
o
F water to work prop-
erly, while some need temperatures of 150
o
F.
The proper design of a RFH system will make the difference between your satisfaction or
dissatisfaction. Several factors such as slab insulation, tube length, spacing, floor covering and heat loss
will affect the performance of your system. The RHP has no control over these important factors.
The RHP simply moves the heated water to the RFH(s) based on instructions from the thermostat. There
is no need to modify, cut, change, or otherwise alter the RHP. Doing so will void warranty.
Introduction
Introduction
Features/Benefits
Capacity
Function
Performance
Expectations
Disclaimer
NIBCO shall not be responsible for any errors in catalogs, brochures or printed materials. NIBCO
reserves the right to alter its products at any time without notice. NIBCO
®
PEX is a trademark of
NIBCO INC. All Rights Reserved.