NIBCO Inc.
7
1516 Middlebury Street • Elkhart, IN 46516 USA • 888-446-4226
PC-2, PC-3, PC-4 Pressing Chains
5. Depress the lock pin on the PC-100 tool (see figures
below) and rotate counterclockwise to disengage
the pin on the pressing tool.
Operation
(cont’d)
6. Install the adapter jaw into the pressing tool and
align mounting hole in jaw with pin. Depress the pin
to secure the adapter jaw (see figures below).
7. Compress the ends of the adapter jaw together to
open the jaws and install the adapter jaw into the
pressing chain (see figures below).
8. Reinstall the battery and depress the tool trigger
to press the fitting. Continue to depress the trigger
until the relief valve actuates and the drive rollers
automatically retract.
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Notes:
If the drive rollers do not automatically retract, the
press is incomplete.
The pressing cycle can be interrupted at any
moment by releasing the trigger.
It is normal for the battery load display to light at both
the beginning and near the end of the pressing cycle.
9. Release the trigger until the drive rollers retract
completely.
10. Compress the adapter jaw ends together to open
the jaws and remove the adapter jaw from the
pressing chain (see below).
Figure 15
Figure 16
