NIBCO Inc.
6
1516 Middlebury Street • Elkhart, IN 46516 USA • 888-446-4226
PC-2, PC-3, PC-4 Pressing Chains
1. Select the proper size pressing chain for the
intended application. Examine the chain for wear,
damage, dirt or copper buildup. Replace if worn or
damaged and remove any dirt or copper buildup
with a brush or soft cloth with light lubricating oil.
2. Disengage the release pin on the pressing chain
(see figures below) and open the chain. Install the
pressing chain around the fitting to be pressed and
re-engage the pin on the pressing chain.
3. Check that the red protective sleeve is in the rear
position and the
chains 2-1/2" to 4"
marking is
visible on the PC-100 tool. If not, depress the button
on the protective sleeve and move the sleeve to the
rear position (see figures below). Release the button
to secure the protective sleeve.
4. Push the retract button on the PC-100 tool to
completely retract the drive rollers (see figure
below).
Before installing the pressing jaws,
remove battery to avoid unintentional
operation.
Failure to observe this warning could
result in severe injury or property
damage.
Operation
(cont’d)
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
