NI PXIe-7975, Начало работы

Страница: 13 / 18

1. Remove the captive screw covers.
2. Install the PXI EMC filler panels by securing the captive mounting screws to
the chassis, as shown in the figure below. Make sure that the EMC gasket is on
the right side of the PXI EMC filler panel.
Figure 6. PXI EMC Filler Panels and Chassis
1
1
3
2
1. Captive Screw Covers
2. Captive Mounting Screws
3. EMC Gasket
Note
You must populate all slots with a module or a PXI EMC filler
panel to ensure proper module cooling. Do not over tighten screws
(2.5 lb · in. maximum). For additional information about the use of
PXI EMC filler panels in your PXI system, visit ni.com/info and enter
emcpanels.
NI FlexRIO FPGA Module Signals
The following figure shows the available signals on the NI FlexRIO FPGA module.
Refer to your adapter module specifications for your adapter module pinout.
© National Instruments
13
PXIe-7975 Getting Started