command runs successfully but LabVIEW still cannot connect, load a different bitfile on
the device.
Why Can't I Detect My Device in LabVIEW?
Complete one or more of the following options to detect your device in LabVIEW:
•
Ensure that the device has been updated with an NI-USRP compatible FPGA.
•
Ensure that the device is powered on and has a valid IP address.
•
Refer to the
NI-USRP Readme
to verify that your version of the NI-USRP instrument
driver supports the Ettus USRP X410.
UHD
Setting Up the Device
Ensure that all of your hardware components are powered off before installing.
1.
Verify that you have all items included in your device kit and the following additional
items.
•
Host PC
•
Network switch
•
CAT 5E Ethernet Cable (optional)
•
One of the following:
–
QSFP28 to QSFP28 Ethernet cable and 100 Gb Ethernet network card
–
QSFP28 to 4xSFP28 Ethernet breakout cable and 10 Gb Ethernet network card
2.
Set all items on a flat surface near power outlets and a modem or router.
3.
Follow the instructions included with your network switch to connect it to a modem or
router.
4.
Follow the instructions included with your host PC to connect it to power and complete
your computer setup.
5.
Connect any additional attachments required for your project to the front panel terminals
of the Ettus USRP X410.
Connecting the Device (UHD)
The following describes one hardware configuration option. Other configurations are possible.
Connect your hardware as shown in the following diagram.
16
|
ni.com
|
Ettus USRP X410 Getting Started Guide
