NHRC- Programming and Operations Guide
Copyright © 2011, NHRC LLC, All rights reserved. Page 9
3.2.4.2 Using the “Special Output Bulk Program” Feature
The NHRC- supports a feature to program the output controls commands to share a common root code,
followed by the port number and either “1” for on, or “0” for off. The root code is a sequence of 1 to 6 DTMF
tones.
The Special Output Bulk Program” feature will program the on and off codes for all eight outputs at once. Each port
is then controlled by sending the root code, port number, and either “0” for off or “1” for on.
Examples
All of these examples assume that the “Program-Command” command has not been reprogrammed to something
other than the factory default of “*3”. If the “Program Command” command has been re-programmed to something
other than *3, replace *3 with the new command code in the examples shown below.
Sending the following DTMF Command will re-program all 16 (eight on and eight off) port commands to start with
code “4321”:
*3 99 4321
Resulting programming:
Command Action
4311 1 0
port 1 off
4311 1 1
port 1 on
4311 2 0
port 2 off
4311 2 1
port 2 on
4311 3 0
port 3 off
4311 3 1
port 3 on
4311 4 0
port 4 off
4311 4 1
port 4 on
4311 5 0
port 5 off
4311 5 1
port 5 on
4311 6 0
port 6 off
4311 6 1
port 6 on
4311 7 0
port 7 off
4311 7 1
port 7 on
4311 8 0
port 8 off
4311 8 1
port 8 on
The “root code” can be from 1 to 6 digits in length. Beware of command collisions as described in Section 3.2.4
Содержание NHRC-Remote+
Страница 18: ...NHRC Remote Programming and Operations Guide...
