ZigBee Wireless Indoor Carbon Monoxide (CO) Detector ( Voice alarm)
Model: SG-02-CO-S1 for stand-alone / SG-02-CO-H1 for ZigBee
使用前
Before installing the detector
1. Safety Notice
To protect your safety , please note below safety notice. Please make
sure the Site of installation is safe during your installation, watch your
feet and position, danger could happen if you do not keep your eyes
on your environment.
Please keep tools, such as battery, screws and screw drivers away
from children. Children could accidentally swallow or hurt themselves
if they get those tools.
Please keep your ears a certain distance from the siren, it may hurt
your ability of hearing if you get too close to the siren while it is
activated at the time.
There are two ways of mounting the detector, wall-mounted and ceiling mounted.
Warning
Please make sure your personal safety in mounting the detector,
position in installing the detector is very important and should pay
high attention to avoid accidents.
Please make sure the screws have been fixed tightly on wall, any
fallen parts or detectors itself may cause damage of the detector.
Please strengthen the wall or ceiling with a supplement board in
softer wall or ceiling to avoid the damage cause from fallen parts
or detector itself.
Please make sure the screws or any wooden dust will not fall into
eyes during installation. Please clean the dust as soon as possible
if it happens and call doctor for careful check of health of installer.
6. How to mount the detector
5. Installation Position
SG02C
O_U16DEC13
Ceiling
100 mm
300 mm
(Maximum)
100 mm
(Minimum)
Acceptable here
“Dead Air Space”
NEVER install here
Top of Gas detector
acceptable here
Side Wall
Warning
Please install the detector as centered as possible, false alarm could
happen frequently because of iinappropriate installation position.
◤
Please install the detector over 30 cm and within 60 cm from the ceiling or
(clarify meaning) in wall-mounted style (for Natural Gas).
※
Places where the CO detector should avoid installing :
(1) Cooking area with frequent smoke or steam generating
(2) Outdoor is not allowed to be installed
(3) Bath room or any places inappropriate installation
Bed room Baby room
Kitchen
Hallway/
Corridor
Stair
Living room
Indoor Carbon Monoxide (CO) Detector
Suggested
Installation Location
Detector
Type
1
2
3
4
5
6
7
8
9
Fuel Fired Fireplace
1
2
Stove
3
Furnace
4
Water Heater
5
Dryer
6
Car
7
BBQ Stove
8
Portable Fuel Fired Generator
9
Blocked Vents or Chimney
9
Indoor Carbon
Monoxide (CO)
Detector
◤
Thank you for choosing Nietzsche’s ZigBee wireless CO detector.
◤
Please read the manual carefully and use the detector properly.
◤
Please read every details in the manual and notice every “Warning”carefully.
User Manual
※
Compliant to local legal requirements
※
For Indoor use
※
Contain installation procedure
◤
This CO detector must be installed by a person qualified to carry out electrical
◤
work according to latest national wiring regulations.
2. Notice in use
◤
According to the law, the customer must install the detector(s) indoors and
◤
maintain/ manage the detector’s operation on their own.
◤
Please check if the detector still working properly every six months to make
sure its functions.
◤
Please do not disassemble, modify, scratch, paint or cause shocking impact
◤
on the detector, as these actions may cause damage the detector.
◤
Please note the detector has self-detection function, please be aware of any
◤
indication from the detector no matter it is flash in LEDs or beep, and read
◤
manual to find out the meanings.
◤
Please make sure that the user can hear the alarm when installing the detector
◤
in less used room.
3. Detector Introduction
Fixture
CO detection
chamber
Siren speaker
Test button/
Mute button
The detector
Alert LED : Red
Wireless Link
Status button
(S1)
Wireless Link
LED : Green/Red
What is included in the box
◤
Screws for wall/ceiling mount (3.5 x 25mm)…………………………2 pieces
◤
Screws cap for screws ………………………………………………2 pieces
◤
AC adapter (12V) …………………………………………………… 1 piece
◤
UserManual……………………………………………………………1 piece
Warning
Silicones could permanently damage the detector. Please avoid using
silicone sealant or any household or cosmetic product containing
silicone in the vicinity of the detector.
4. Location of Installation
1/2