NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 80 / 330

4.4 Setting for Main Items
WF1967/WF1968
4-30
4.4.6 To Set Phase
a) Setting procedure
1.
Select the [Phase] field and then press the ENTER
key to open the phase input field.
[Phase] is displayed at first page.
2.
Select the digit to be changed by using the right or
left arrow key, and then use the up or down arrow
key or the modify knob to increment the value. The
change is immediately reflected to the output.
Or use the numeric keypad to enter the value. Press the ENTER key or the unit key
(soft-key) ([deg]) to set the input value. When the ENTER key is used, deg is set as the unit.
b) Items that can be changed in the phase setting
The following items can be changed in the phase setting.

The phase difference between the reference phase synchronous output in the
Synchronization/Sub-output and waveform output can be changed.
The following figure shows
an example of a phase setting
of +90 degree. At this time,
the zero relative position of
waveform output precedes 90
degrees from the rising
position of the reference
phase synchronous output.

The oscillation start/stop phase is changed in burst Oscillation or gated sweep.
The following figure shows an
example of the burst oscillation at the
oscillation start/stop position of +30
degrees. At this time, the oscillation
starts at a +30 degree position, and
also stops at a +30 degree position.
Burst Oscillation

P.4-88, Gated
Sweep

P.4-76.
Waveform output
Synchronization/Sub-output
(Reference phase
synchronization output)
Zero phase
position of the
waveform
Phase setting: +90 degrees
90 degrees
Phase setting: +30 degrees
Oscillation starts at
+30 degrees
Oscillation stops at
+30 degrees