NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 138 / 330

4.9 Setting and Operation of Burst
WF1967/WF1968 4-88
4.9 Setting and Operation of Burst
4.9.1 Burst Oscillation Types(Burst mode)
The following 4 types of burst oscillations are available.
• Auto burst
Repeat oscillation and stop automatically at the specified by waveform respectively. A trigger signal is
not necessary.

P.4-90
• Trigger burst
Every time a trigger is accepted, perform oscillation with the specified frequency.

P.4-93
• Gate Oscillation
While the gate is On, performs an oscillation with an integer cycle or half-cycle unit.

P.4-98
• Triggered Gate Oscillation
Gate oscillation that turns the gate On/Off every time a trigger is accepted.

P.4-102
4.9.2 Screen for Setting and Operation of Bursts
This section describes the common screen structure in the burst oscillation mode.
Settings and operations are performed in the Oscillator setting screen. When you press the MENU key
while another screen is displayed, the Top menu is displayed. Select [Oscillator] and then press the
ENTER key.
a) To set oscillation mode as burst
b) First page of the setting screen: Basic parameter setting screen
These are common items which are independent of the oscillation mode.
c) Second page of the setting screen: Screen for Setting Bursts
Settings differ depending on the burst mode. This is explained for each burst mode.
Press the MODE key to open the oscillation mode
selection list. Select the burst oscillation mode
[Burst]. (

P.4-27) This switches to burst oscillation
mode.
There are 3 pages of setting screens in total in the
burst oscillation mode. You can switch pages by
using the NEXT soft-key.
Setting of start
oscillation/stop phase
Indicates that the first page
is displayed
Pressing the NEXT
key switches the
display to the
second page
To set the oscillation mode to [Burst] (

P.4-27)