Nexus X-BLUE, Руководство по эксплуатации, Страница: 12 / 16

22 23
How to Replace the Filter
5
Insert the new filter into the compartment.
-Remove the plastic caps covering both ends of the new filter.
-Seat the large opening on the bottom of the filter cartridge onto the base.
- Push the filter down and into the housing compartment ensuring the
opening at the top of the filter is seated properly into the fitting at the
top of the housing
Check for leaks by running water through your ionizer before replacing the
housing cover.
Flush out the GAC carbon dust.
- The water will initially come out discolored (light to charcoal
gray) due to carbon particulates in the new filter.
This is not harmful and is typical of all GAC filters.
Allow the water to flow for 2-3 minutes in the "Purified" mode
and this will flush all the carbon dust.
6
7
Immediately after filter replacement, the water will come
out black and unclear due to the activated carbon particulates
in the new filter but will become clear momentarily.
(It is not harmful.)
Reset
Button
Reset the filter life indicator.
- With your ionizer in standby mode (water not runni ng through the ionizer)
press the "Reset" button located at the top of the filter housing compartment
for 3~5 seconds.
- Replace the filter housing cover.
4
Remove the expired filter.
-Taking hold of the filter securely with you right hand, press the
filter firmly down against the spring loaded mechnism to disengage
the top of the filter and then lean the filter out toward you and lift up
to remove it.
-The upper part of the filter is separated from housing by pressing
firmly down. Once you have engaged the spring loaded mechanism,
you can then easily remove the filter from the main body by
leaning the filter out toward you and life up to remove it.
Filter
WARNING INDICATORS
1) LOW PRESSURE - The Low Pressure Warning indicator will flicker
when water flow or pressure into the machine is weak.
Increase the water flow to resolve this condition.
2) HOT WATER - The Hot Water Warning indicator will flicker when you
have inadvertently run hot water into the machine.
Switch back to cold water immediately to resolve this condition.
Allow the cold water to flow for about a minute.