C-4.4 Installation Instructions
Rev 1; 6-25-07
14
Figure 8 Typical Zone Configuration
Keypads
Pull CAT-5 in home-runs directly from each keypad location to the C-4.4 Controller location. Terminate
with RJ45 plugs in a pass-through (pin to pin) configuration using the TIA568A Standard pin-out.
CAT5
RJ45
SIGNAL
White/Green PIN
1
+12V
Green
PIN 2
GND
White/Orange
PIN 3
Keypad Data +
Blue
PIN 4
IR Data +
White/Blue
PIN 5
IR Data -
Orange
PIN 6
Keypad Data -
White/Brown PIN
7
N/C
Brown
PIN 8
N/C
Figure 9 RJ45 TIA568A Standard Pin-out
Speakers
Pull four conductor wire in home-runs directly from each speaker location to the C-4.4 Controller location.
WIRE GAUGE:
16AWG stranded up to 75’; 14AWG stranded up to 100’. Non-shielded preferred.
NOTE:
MAX LOAD:
8 ohms per zone. Do not load more than one pair of 8 ohm speakers per zone. This
can cause the unit to go into protection and may possibly blow fuses.
Video
(Option)
Though the C-4.4 does not switch video signals, video cable should be pulled to allow whole-house video
distribution with audio signals routed through the C-4.4 rather than the TVs for improved audio
performance. Pull RG6 coaxial cable in home runs directly from each possible TV or video display
location directly to the C-4.4 Controller location. RG6 quad shield preferred. Coaxial cable length will vary
with system design. Terminate with appropriate quality gold-plated connectors.
