EN
3.3 - PROCEDURE FOR THE DUPLICATION OF A “COPIER REMOTE CONTROL” WITH ANOTHER COPIER
REMOTE CONTROL
This procedure makes it possible to duplicate an already cloned button of a “copier radio control” on another “new copier
radio control”.
If I am copying a
fixed code or a
rolling type 1
If I am copying a
rolling type 1
STEP 1
Press and hold button 1 of the “copier radio
control”, and simultaneously press key 2 for 4
times
STEP 2
Release both buttons. At this point the RED LED
of the “copier radio control” will emit a
short flash about every 2 sec.
STEP 3
Position the “remote control to be cloned” in front of the
“copying radio control” at a
distance of about 1-2 cm
STEP 4a
Wait for the RED LED of the “new copier
transmitter” to change flashing (faster
flashing) and color (GREEN), confirming the
correct learning of the code. This can take a
few seconds.
STEP 5a
While the GREEN LED is flashing, press the
key of the “new copier transmitter” on which
you want to enter the code just learned and
keep it pressed until the LED switches off to
confirm the correct learning of the code.
STEP 4b
The RED LED of the “copier transmitter” will emit a short flash about
every 2 seconds. Now transmit the SEED CODE of the “remote
control to be cloned” by simultaneously pressing keys 1 and 2 for
about 3 seconds, until the RED LED lights up. While the LED is
flashing (within 10 seconds) press and hold down the key whose
source code you want to copy.
STEP 5b
The RED LED of the “copier remote control” will now change
flashing (faster flashing) and color (GREEN), confirming the correct
learning of the code. This can take a few seconds.
At this point, press the key of the “new copier remote control” in
which you want to store the code and keep it pressed until the LED
turns off to confirm the correct learning of the code.
STEP 6
Insert the “programmed copier radio control” with the remote learning procedure (depends on the model copied) or with
a standard association procedure. See paragraph 4).
11
x4
1-3cm
New
