EN
If the remote
control is a
BFT model
If the remote
control is a
GENIUS model
If the remote
control is a V2
model
3.2 - PROCEDURE FOR THE DUPLICATION OF A TYPE 2 ROLLING CODE (BFT, V2, FAAC)
STEP 1
Press and hold button 1 of the “copier radio
control”, and simultaneously press key 2 for 4
times
STEP 5
The RED LED of the “copier remote control” will now change flashing (faster
flashing) and color (GREEN), confirming the correct learning of the code.
This can take a few seconds.
this point, press the key of the “copier radio control” in which you want to
store the code and keep it pressed until the LED turns off to confirm the
correct learning of the code.
STEP 6
Add the “programmed copier radio control” with the remote learning procedure (depends on the model copied) or
with a standard association procedure. See paragraph 4
STEP 2
Release both buttons. At this point the RED
LED of the “copier radio control” will emit a short
Flash about every 2 sec.
STEP 3
Position the “remote control to be cloned” in front of the
“copying radio control” at a distance of about 1-2 cm, then
Press and hold the button to be copied of the “remote
control to be cloned” and wait for the RED LED of the
“copying radio control” to turn on steadily, then release the
button.
The RED LED of the “copier remote control” will emit a
short flash about every 2 sec.
STEP 4a
Now transmit the source code of
the original BFT remote control
(by pressing the button hidden
on the back with a pin, or in the
case of more recent models by
simultaneously pressing buttons 1
and 2 until the LED of the original
remote control lights up).
STEP 4c
Press keys 1 and 2
simultaneously and
when the LED flashes
release them (Note:
THEY ARE THE KEYS
OF THE DIAGONAL as
shown in the image).
STEP 4b
Now transmit the source code
of the original V2 remote control
by pressing keys 1 and 2
simultaneously.
10
x4
1-3cm
