NOTE: Flame function can be controlled by either
control panel or remote control.
CAUTION:
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied
through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off
by the utility.
2. When you press the " " button 3 times, you
turn off the flame effect. All of heating functions are
switched off too.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Your appliance is guaranteed for one year from the date of purchase against any manufacturing defect If you
encounter a problem, please contact customer services.
SAFETY CUT-OUT SYSTEM:
BACKLIGHT CONTROL
MAINTENANCE
TROUBLE SHOOTING
1. You can switch ON/OFF the backlight through the
switch designed at bottom of engine as shown.
ENVIRONMENTAL PROTECTION
This appliance has a safety cut out system, which will activate if the air inlets or outlets are obstructed and the fire
begins to overheat. For safety reasons the fire WILL NOT switch on again automatically. The following procedure
must be carried out before the fire can be operated again:
1. Unplug the power supply cable and switch off the heater at the appliance.
2. Leave the fire switched off for a period of no less than 15 minutes, ensuring any obstructions are removed.
3. Plug the power cable back in at the socket, and switch on at the appliance.
NOTE:
• If the appliance fails to operate, repeat the above procedure.
• If you attempt to switch the appliance back on before the safety cut out has reset, the heater may cut out for a
further period of time. If the sequence has been followed correctly and the heater still fails to function, check if the
plug is correctly in the socket OR only when the fire has completely cooled use a vacuum cleaner to clean around
the air inlet and outlet vents.
Page 5 of 6
