- Installation instructions for supplementary outriggers -
Via Mediterraneo, 6 - 42022 - Boretto - Reggio Emilia - Italy
Tel. +39 - 0522-96 30 08 - Fax +39 - 0522-96 30 39
- 35 -
18.3 - Regular checks
18.3.1 For all the models
Weekly:
-
Check for presence of oil leaks from hoses / pipings and fittings, if any, find out and remove their
causes.
-
Check for damages or wear on hoses and piping.
-
Check the locking pins and safety latches: They must be efficient and perfectly working. If bent,
broken, damaged or missing of any item, they must be immediately replaced or repaired at authorized
workshop.
-
Check integrity and efficiency of the devices supporting and driving the hoses whilst extending.
18.3.2 Stabilizer models “ML”, “0”, “1”, “2”, “3”
-
Weekly:
Carry out a visual checking making sure that the cylinders
did not move upwards or that, with cylinders in transport
position, there is no clearance between the locking collar and
the sleeve; in case one of the above situations occurs, have
screw tightening checked by an authorized workshop.
(Pict. 39)
-
Yearly:
Have screw tightening checked by an authorized workshop
and, if necessary, restore it tightening by torque wrench,
according to what shown in Tab. 1.
Each operation beyond what described has always to be approved
by
Next Hydraulics’
Technical Department, whom you have to
apply to for any clarification and further information required.
18.3.3 Tilting legs models
Quarterly:
Check that the pivot (1) and its bushing (2) are correctly greased. If
not, apply grease through the relevant grease nipple (3). (Pict. 40)
18.3.4 Foot plates on stabilizer legs
(Ref. picts. 39, 40 Pos.4)
Weekly:
Check that the bearing surface is plane, without damages nor
deformations. If not, replace with original parts.
1
2
Pict. 40
3
Pict. 39
4
4
3
1
2
- Use and maintenance manual -
